![]() It is important to have the rope manufacturer's instructions and the right size fid to make one of these splices. It works much like the braided bamboo Chinese finger puzzle that children play with. The third, and most commonly used, method of eyesplicing braided line is with a special fid that permits you to insert the end of the line back into the core of the braid. Note that the serving mallet shown in the illustration is not absolutely necessary, but is a great help toward getting a tight serve. Taper the unlaid rope yarns or it will be impossible to apply a serving to the decreasing diameter of the splice. Pass the sail needle right through the rope each time and tug the stitch home tightly. It is important that stoppings, sewing, and finally serving are tight and neat, otherwise the eye splice resulting will be loose and weak. Finish by seizing ends as illustrated on the previous page.Īnother technique for eye splicing braided line is "sew & serve," illustrated below. Thereafter the paired strands are divided and tucked separately. ![]() After whipping or stopping at the point of splice, divide the various Z and S strands as shown and tuck in two pairs front and back of the work. The eye splice used is based upon the construction of the rope, which employs both "Z," or right-handed lay strands, and "S," or left-handed strands. The illustration below shows how you can tuck an eye splice into double, four-part braid. There are several ways to eye splice braided rope. With manmade fibers the rope ends can be fused together by heating. This splice is only good with natural fiber ropes. Then tuck the strands "over one and under one" backward toward the standing part of the rope. Where a line is not required to run through a block - when whippings are preferable - a back splice may be used to prevent the strands unlaying.Īfter unlaying the strands for the estimated distance, form a crown by interlacing the strands at the rope's end. Pull very tight and then taper off by reducing the yarns in each strand.Make an overhand knot with each pair so that the ends follow the lay of the rope and do not cross it. The third pair of strands (at 'a' in the illustration) are left in their original place, so that there are now three pairs of ends.Repeat with two more strands but work in the opposite direction.Cut off surplus from the end that is unlaid. Select two ends that cross one another from opposite sides, unlay one of them for some length, and lay into its place the opposite strand from the other rope until only a short piece is left.Marry the ends together as though about to begin a short splice.Unlay the ends of two ropes to at least four times the distance required for a short splice.Seldom used, but very useful as a temporary measure that is, until the rope can be replaced with a new one - for a line that is required to run through a block because the splice does not thicken it (See Fig. If the line is to bear any strain, make at least three rounds of tucks each way.Tucks are made toward the left by passing each end, in turn, over one strand and under the next, in the same manner as described for the eye splice. Marry these ends together, so that the strands of one rope lay alternately between the strands of the other.Unlay the two ends to be joined-at least one turn for each round of tucks to be made.If desired, for neatness, the splice can be tapered by adding additional rounds of tucks, first with halved strands and then by halving again before the final round.įor joining two ropes of the same size together.Never use less than three rounds of tucks if the eye is to bear any strain. For the second round, take each end over one strand and under the next towards the left.Pull each end tight enough to make a tidy and snug fit.If two ends come from under the same strand, the splice is wrong. ![]() There should now be one end coming out from under each strand on the standing part.Turn the whole splice over, then take the third end (C) and lead it over to the right of the third strand, so that the third tuck can, again, be made from right to left, as in step 3.Pick up the left end (B) and tuck it - again from right to left - under the next strand to the left of the one under which (A) is tucked.Take the middle end (A) and tuck it, from right to left, underneath the nearest strand of the standing part.Unlay the three strands at the end of the rope, enough to make at least three tucks - about one turn for each tuck - and form an eye by laying the opened strands on top of the standing part of the rope.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |